How to purchase Smart Junction Box and install it

When install after purchasing Smart Junction Box ,it should be selected from the ground level of 1.3 ~ 1.5m of the place, if the room is equipped with wall board should be at least 20cm away from the wood over the top, to avoid fire and other troubles. Followed by the switch, socket panel should be installed upright, tight, and flush with the wall; for surface line of switches and sockets should be installed in surface mounted back box on the kitchen switches and sockets should be fitted with waterproof cover necessary to avoid water into the box lead to short-circuit phenomenon.

Installed in the socket when not installed in the bed or on the desktop and other wood materials, so the user does not accidentally touch live within the socket body; If there are children of the user, then the next outlet installation height should be not less than 1.8m; It is noteworthy that the place where the requirements of the ground, are protected sockets should be used with that single-phase equipment with three-hole socket, three-phase equipment with four-hole outlet, there must be grounded guaranteed. Installation.

All wires and wiring studs should be fully exposed, and may not have rust, oxidation, these defects easily lead to accidents; try to avoid multi-strand wire at the same time into the same terminal, the load exceeds the power lines caused by overload; Install button bit terminal block, the first panel can be removed, to be loaded again when the renovation is completed, or with a plastic bag wrapped around panel assembly, fitting the environment to avoid fouling phenomenon caused by the panel; special attention should be in line no wiring power circumstances.